SE-SR2
Operating instructions SE-SR2
826002433-EN-Rev.C
9
}
Output safe: Safety contacts
}
Output aux: Auxiliary contact
}
[1]: Automatic start
}
[2]: Manual start without control
}
[3]: Manual start with control
}
a: Input circuit closes before start circuit
}
b: Start circuit closes before input circuit
}
t
1
: Switch-on delay
}
t
2
: Delay-on de-energisation
}
t
3
: Recovery time
}
t
4
: Waiting period with a monitored start
Installation
}
The unit should be installed in a control cabinet with a protection type of at least IP54.
}
Use the notch on the rear of the unit to attach it to a DIN rail (35mm).
}
When installed vertically: Secure the unit by using a fixing element (e.g. retaining
bracket or end angle).
Wiring
Please note:
}
Information given in the "
}
Outputs 13-14, 23-24, 33-34 are safety contacts; output 41-42 is an auxiliary contact
(e.g. for display).
}
Auxiliary contact 41-42 should
not
be used for safety circuits!
}
To prevent contact welding, a fuse should be connected before the output contacts (see
).
}
Calculation of the max. cable length l
max
in the input circuit:
R
lmax
R
l
/ km
I
max
=
R
lmax
= max. overall cable resistance (see
R
l
/ km = cable resistance/km
}
Use copper wire that can withstand 60/75 °C.
}
Do not switch low currents using contacts that have been used previously with high cur-
rents.
}
Sufficient fuse protection must be provided on all output contacts with capacitive and in-
ductive loads.
}
The power supply must comply with the regulations for extra low voltages with protect-
ive electrical separation (SELV, PELV) in accordance with VDE 0100, Part 410.
}
Ensure the wiring and EMC requirements of EN 60204-1 are met.
Содержание SE-SR2
Страница 1: ...SE SR2 Safety relays 22 224 06 ...
