Datalogic PowerScan PD9530, Руководство по продукции

Страница: 252 / 362

Enter/Exit Programming Mode
242 PowerScan™ PD9530/PBT9500/PM9500
Base Address Stamping
Enables/disables the ability of base address information to be transmitted to
the host and, if so, at what position with respect to the label data. See
page 304 in “References” for detailed information and examples for setting
this feature.
DEFAULT
$CCNAS00(CR)
Base Address Transmission = Do Not Include
$CCNAS01(CR)
Base Address Transmission = Prefix
Base Address Delimiter Character
This option specifies the delimiter character to be placed between the label
data and base address when address stamping is enabled.
$CCNAD
Set Base Address Delimiter Character
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by two digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character. End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
00 = No Delimiter Character
This feature only applies if
"Base Address Stamping"
on page 242
is enabled.