Enter/Exit Programming Mode
Product Reference Guide
47
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
See
in “References” for detailed information and examples for set-
ting this feature.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then
the bar code at left followed by the digits from
the Alphanumeric characters in
representing your desired character(s).
End by scanning the ENTER/EXIT bar code
again.
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can
then start again at the beginning.
CANCEL
DEFAULT
00 = No Wedge Intercode Delay
Содержание PowerScan 9501-AR Series
