Datalogic Pegaso, Руководство по установке, Страница: 14 / 36

Electrical Considerations
8
Pegaso™ Powered Mobile Dock
Electrical System Connections
This section covers electrical connection to +12V, +24V, +36V and +48V sys-
tems.
Connection to +12V
Figure 4 illustrates a typical wiring connection for a +12 volt system. The
input voltage operating range of the dock will allow direct connection to the
battery terminals. However, the use of a 5-Amp fuse is required, and a Noise
Spike/RF filter is highly recommended.
Accessory equipment may also be required depending on your application,
Refer to Table 1 on page 2-7. Read and follow all manufacturer's installation
instructions carefully.
Figure 4. Wiring Diagram for +12V Systems
CAUTION
Proper installation requires that source power connections be made directly
to the mobile platform’s positive and negative battery terminals. It is
important to maintain electrical isolation when installing the Powered
Mobile Dock and any accessory equipment, to ensure safe and proper
operation. Do not make any electrical connections directly to the chassis of
the forklift.
Noi s e/ S pike Filter
(Recommended)
DC Conditioner/UP S
(Optional)
Delay Timer
(Optional)*
U s e crimp connector s
for all wire connection s
Dock
Power Cord
Red (Po s )
Black (Ne g )
Po s
+
Ne g
-
5-Amp In-Line Fu s e
(Required)
EN S URE that the device bein g
in s talled i s properly rated for u s e
on your mobile platform.
*
Fu s e each device accordin g to
manufacturer ’s recommendation