Datalogic Pegaso, Краткое руководство пользователя

Страница: 31 / 60

Troubleshooting
Quick Reference Guide 29
Rechargeable
battery pack did
not charge.
Battery failure.
Replace the battery. If the terminal still does
not work, do a warm reset, then a cold reset;
refer to
Resetting the Pegaso on page 2-26.
The unit was
removed from the
dock while battery
was charging.
Insert the Pegaso in dock and begin charging.
The battery pack and backup battery require
4 hours to fully charge.
Characters are not
visible on the
display. The Pegaso is not
powered on.
Press <PWR> .
The ambient room
light is too dark or
low.
The Ambient Light Sensor may not be func-
tioning properly.
No sound is
audible.
Volume setting is low
or turned off.
Adjust the sound by going to > Settings
> Personal > Sounds & Notifications -- OR-
Scan a barcode from the PRG .
The Pegaso turns
itself off.
The Pegaso is inac-
tive.
The Pegaso turns off after a period of inactiv-
ity. You can set duration from 1-30 minutes.
Refer to the
PRG .
During data
communication,
no data was
transmitted, or
transmitted data
was incomplete. The Pegaso was
removed from dock
or unplugged from
host PC during com-
munications.
Replace the terminal in the dock or replace
the serial cable, and retransmit.
Incorrect cable con-
figuration.
See your System Administrator.
Communication soft-
ware was incorrectly
installed or config-
ured.
Perform setup as described in the PRG .
Problem Possible Cause Solution