Datalogic MAGELLAN 8500?, Руководство по продукции

Страница: 64 / 456

2-34
Magellan
®
8500 Scanner
3. Depending upon the model type, the method used to lift the unit
will vary. For the first model type, hook the fingers of both hands
into the lift handles located along the insides of the scanner walls,
just above the debris chutes as shown in
Figure 2-23
a. Other mod-
els contain lift handles that must be rotated up into position for
use as shown in
Figure 2-23
b. DO NOT attempt to lift the unit
using the plastic edges, scale frame, or any features other than the
lift handles.
4. Lower the unit into the counter opening, ensuring that none of
the cables are pinched, pierced or crimped.
5. Reinstall the All Weighs™ Platter and verify that it is flush or just
below flush with the countertop. This is necessary to provide
smooth scanning from either direction. Make adjustments as
needed to align the platter with the counter by moving support
rails up or down, or consider installing screws in positions that
will allow their use in adjusting the unit’s position.
6. Once installation is complete, proceed with the
Operational Verifi-
cation
procedures that follow.
Figure 2-23. Using the Lift Handles
NOTE
Failure to install a scanning-scale in a stable and level position will inhibit
weighing, calibration and zeroing operations. The platter MUST make unob-
structed contact with all of its supports for proper weighing operation.
Lift Handles
a b
...or rotate Lift Handles up
or...