Datalogic Magellan 800i, Руководство по продукции

Страница: 53 / 168

Enter/Exit Programming Mode USB COM Interface Set-up
45 Magellan™ 800i Scanner
Intercharacter Delay
• If the transmission speed is too high, the system may not be able to receive all characters.
You may need to adjust the delay to make the system work properly. Selectable from 00 to
99.

USB Keyboard: 00 = 1 ms USB Host poll rate. Non-zero values less than 25 are 10 ms
increments in USB Host poll rate values greater than 25 result in a USB Host poll rate of
255 ms.

To configure this feature, scan the ’Enter/Exit Programming Mode’ bar code above to
place the unit in Programming Mode, then the “Set Intercharacter Delay,” followed by the
two digits (zero padded) from the Alphanumeric table in Appendix C, Alphanumeric Pad
representing your desired length. Exit programming mode by again scanning the ’Enter/
Exit Programming Mode’ bar code above/
DEFAULT SETTING FOR THIS FEATURE:
01
0287(CR)
Set Intercharacter Delay
USB COM Interface Set-up
To set the reader to use the USB Com interface, follow these instructions:
1. Download and install the USB Com driver available from the www.data-
logic.com website.
2. Program the reader for the USB Com interface using the bar code located
on page 28.