Datalogic lynx bt, Справочное руководство

Страница: 22 / 200

LYNX™ BT
1
1.2 LYNX™ BT BATTERIES
To begin using your Lynx™ BT you must charge its Li-Ion batteries using the OM-1000
cradle or the C-1000 battery charger as described in the following paragraph.
Battery Charging
The first operation to perform is to connect the OM-1000 or the C-1000 to the power
converter and firmly insert the Lynx™ BT into the cradle to charge the batteries. The
red Charging LED will light. When the battery is completely discharged, a full charge
takes up to 4 hours. The Batt. Full LED will light when charging is completed. Press the
reader trigger to turn it on.
Figure 1 – OM-1000 BT Charging Batteries
The LEDs positioned on the cradle or on the battery charger signal the charge status,
as described in the following table:
LED STATUS
Charging Red On = the battery charge is in progress
Batt Full Green On = the battery is completely charged
NOTE
The batteries must be charged at a temperature ranging from 0° to
45 °C (+32° to +113 °F).
Power Cable
2