INTERFACE SELECTION
Follow the procedure to configure the interface required by your
application
-
USB Interface
-
RS232 Interface
-
Wedge Interface
-
Pen Interface
USB INTERFACE CONFIGURATION
The USB interface is compatible with:
Windows 98 (and later)
IBM POS for Windows
Mac OS 8.0 (and later)
4690 Operating System
START-UP
As with all USB devices, upon connection, the Host performs
several checks by communicating with the Heron™. During this
phase the green LED on the Heron™ reader blinks and normal
operations are suspended. Two basic conditions must be met
before Heron™ is ready to read codes, the correct USB driver
must be loaded and sufficient power must be supplied to the
reader.
For all systems, the correct USB driver for the default
USB-KBD interface is included in the Host Operating System
and will either be loaded automatically or will be suggested by
the O.S. and should therefore be selected from the dialog box
(the first time only).
If the Host supplies sufficient power to the reader, the start-up
phase ends correctly, the green LED stops blinking and the
reader emits the beep OK signal.
If the Host does not supply sufficient power to the reader, a
dialog box will appear on the Host and the reader will be
blocked (green LED continues blinking). In this case,
disconnect the Heron™ USB cable at the Host (green LED
stops blinking), connect and power-up an external supply to the
Heron™ USB cable then reconnect the Heron™ USB cable to
the Host and close the dialog box. The reader emits the beep
OK signal. You can now read codes. At this point you can read
the USB interface configuration code according to your
application. Load drivers from the O.S. (if requested). When
configuring the USB-COM interface, the relevant files and
drivers must be installed from the USB Device Installation
software which can be downloaded from the web page
http://www.datalogic.com/services/support/.
The reader is ready.
TECHNICAL FEATURES
Heron
D130
Electrical Features
Power Supply
RS232
interface
5 Vdc
±
5%
Consumption:
Maximum
Operating
Sleep
mode
USB Suspend Mode
180 mA @ 5 Vdc
155 mA @ 5 Vdc
120
µ
A @ 5 Vdc
350
µ
A @ 5 Vdc
Max. Scan Rate
256 scans/sec
Reading Indicators
LED, Good Read Spot, Beeper
Optical Features
Sensor
CCD solid state (2048 pixels)
Illuminator LED
array
Wavelength
630 ~ 670 nm
Max. LED Output Power
0.31 mW
LED Safety Class
Class 1 EN 60825-1
Reading Field
see reading diagrams
Max. Resolution
0.10 mm (4 mils)
PCS
min. 15% (Datalogic Test Chart)
Environmental Features
Working Temperature
0
°
C to + 55
°
C
Storage Temperature
-20
°
C to + 70
°
C
Humidity
90% non condensing
Drop Resistance
IEC 68-2-32 Test ED
ESD Protection
16 KV
Protection Class
IP30
Mechanical Features
Weight (without cable)
about 160 g. (7 oz.)
Cable Length
2 m (6.1 ft.)
