Datalogic Gryphon I GD4132, Руководство по продукции

Страница: 82 / 354

ENTER/EXIT PROGRAMMING MODE
80 Gryphon™ I GD4132/GM4102/GBT4102
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or
any hex value from 00 to FF. The characters may be added as a prefix (in a
position before the barcode data, also called a header) and/or as a suffix (in a
position following the barcode data, also called a footer). See page 297 for
more detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode
above to place the unit in Programming Mode, then the “Set Global Prefix” or
“Set Global Suffix,” barcode followed by the digits (in hex) from the Alphanu-
meric characters in Appendix D, Keypad representing your desired character(s).
If less than the expected string of 20 characters are selected, scan the ENTER/
EXIT barcode to terminate the string. Exit programming mode by scanning the
ENTER/EXIT barcode again.
Set Global Prefix
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
No Global Prefix

Global Suffix = 0x0D (CR)