Datalogic Gryphon I GD4132, Руководство по продукции

Страница: 280 / 354

Wireless Features ENTER/EXIT PROGRAMMING MODE
278 Gryphon™ I GD4132/GM4102/GBT4102
BT SECURITY FEATURES
The BT system can be set up to require a configurable PIN code to authenticate/
connect BT devices, and encrypt the data. This can be done in one of two ways:
• The scanner can be programmed with a PIN code using the bar codes in
this section.
• The Host can be set up to specify a custom security PIN code when a scan-
ner attempts to connect. For more information about this feature, contact
Datalogic Technical Support.
The Gryphon GBT4102 can be set up to require a PIN code when connect-
ing to the host. If you are adding new equipment to a system that uses a
custom security PIN, please read this section for information before pro-
ceeding.
Follow these steps to set the PIN code for a scanner:
1. Enable BT Security Mode by scanning the "Enable” bar code below.
2. Select a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in "Select PIN Code Length" on page 279.
3. Scan the relevant bar code from "Set PIN Code" on page 279, then scan the
desired alpha-numeric characters from the keypad in Appendix D, Keypad
to set the PIN code.
See "BT-Only Features" on page 313 in "References” for more detailed informa-
tion and examples for this feature.
BT Security Mode
This feature enables/disables authentication and encryption of the BT link. Use
the feature "BT Pin Code" on page 279 to specify the pin code used to authenti-
cate the BT Link.
DEFAULT
BT Security Mode = Disable
BT Security Mode = Enable
Changing the security mode setting will unlink the devices. If the Auto-
matic Configuration Update is set to the default enabled setting, the
devices must only be relinked. If the Automatic Configuration Update is
set to the disabled setting, the Security Mode setting must also be
updated in the Base Station using Aladdin. After the Base Station has
been updated the devices must be relinked.