Datalogic Cobalto C05300, Руководство по продукции

Страница: 72 / 292

Enter/Exit Programming Mode Label Gone Timeout
60
Cobalto™ CO5300 Scanner
Label Gone Timeout
This feature sets the time after the last label segment is seen before the scanner prepares for
a new label. The timeout can be set within a range of 10 milliseconds to 2,550 milliseconds
(2.55 seconds) in 10ms increments. Label Gone Timeout does not apply to scan modes that
require a trigger pull for each label that is read. See
Label Gone Timeout on page 237
for
more detailed programming instructions.
Select Label Gone Timeout Setting
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
016 = Timeout of 160 ms
$CSNLG
~