Selecting the Interface Type
Quick Reference Guide
9
Configuration Bar Codes
Link the cradle and the reader using the procedures described in the Power-
Scan
™
PM9500 Quick Reference. Once the pairing is complete, you can config-
ure the BC9xx0 cradle by reading the configuration bar codes in this manual.
To configure the BC9xx0 using the PowerScan
™
PM9500 reader (paired to the
cradle with the Bind command), follow the procedure according to the inter-
face selected.
Selecting the Interface Type
Upon completing the physical connection between the reader and its host,
scan the appropriate bar code for your system’s correct interface type.
Configuring the Interface
Scan the programming bar code which selects the appropriate interface type
for the system the reader will be connected to.
Ethernet Interface (BC9x80 Models only)
Use the programming bar codes below to program the Ethernet interface, to
select between standard and Ethernet/IP and to choose between fixed IP
address and DHCP.
Unlike some other programming features and options, interface
selections require that you scan only one programming bar code
label. DO NOT scan an ENTER/EXIT bar code prior to scanning an
interface selection bar code.
Some interfaces require the scanner to start in the disabled state
when powered up. If additional scanner configuration is desired
while in this state, pull the trigger and hold for 5 seconds. The scan-
ner will change to a state that allows programming with bar codes.
ETHERNET
Select Standard Ethernet
Select Ethernet/IP
