DataComm D14.4, Руководство пользователя

Страница: 7 / 12

7
REMOTE MULTIPLEXER
AT YOUR COMMAND >> CN<Enter>
CONFIGURE NETWORK
-------------------------------
SYNC MODEM
LEASED LINE
ERROR CORRECTION ON
SYNC or ASYNC modem? [S/A] >> A<Enter>
ASYNC rate? [9600 / 19200 / 38400 / 57600 / 115200] >> 57<Enter>
Leased or Dialup Line? [L/D] >> D<Enter>
Enable Error Correction? [Y/N] >> Y<Enter>
Disconnect timeout? [1 to 99 min; 0=Disable] >> 0<Enter>
One-Touch Dialing? [ATDS0 / DTR Dial / OFF] >> AT<Enter>
Send SR call progress messages? [Y/N] >> Y<Enter>
ASYNC MODEM: 57600
DIALUP LINE
ERROR CORRECTION ON
Configure Modem? [Y/N] >> Y<Enter>
*** CONFIGURE MODEM - Type ESC ESC to stop
at<Enter>
OK
at&f &q6<Enter>
OK
at&z0=nnn-nnnn<Enter>
Note: Replace nnn-nnnn with the phone
number of the HOST Multiplexer.
OK
at&w<Enter>
OK
<Esc><Esc>
*** End CA/CC Capture
AT YOUR COMMAND >>
ONE-TOUCH DIALING
To make a connection to the host press <space> or <Enter> from any
terminal connected to the remote multiplexer. When you see “SR:
Connected…” you should be able to log in from all remote terminals.
If you set the remote multiplexer Disconnect timeout to a number
from 1 to 99 (minutes), the connection will hang up if there is no
activity to or from any terminal for that period of time. To
reestablish the connection, type <space> or <Enter> from any
terminal.