DataCard Datacard SP35, Руководство по установке

Страница: 187 / 199

4
SP Series Supply e-Guide
• The print ribbon maintains its quality for about one year. For optimal card quality, purchase and store quantities
that you can use up in less than a year.
• The print ribbon and card stock might require secure storage and tracking. Follow your policy for storing and
tracking the supplies used to make cards.
• Choose a location away from direct sunlight, with a temperature between 32° F and 77° F or between 0°C and
25° C. A humidity range from 40% to 60% (non-condensing) is recommended.
• Supply rolls should be at room temperature when they are installed in the printer and used. If supplies are
stored in a cooler environment than the printer, allow supplies to reach room temperature before using.
• If the printer will not be used for an extended period of time, remove supplies from the printer and store them
with new supplies.
Cards
This section describes specifications and quality guidelines for card stock to use with the SP Series printer. It also
describes the environmental specifications for storage of card stock.
For best results with the SP Series printer, use high-quality card stock that meets the specifications and
recommendations described in this section.
Card size
Use CR-80 size cards with the following nominal dimensions:
Actual card thickness can vary by up to ten percent from the sizes listed. Smart card chips can be raised slightly
from the printing surface.
Length 3.37 inches 85.60 mm
Width 2.125 inches 53.98 mm
Thickness with
smart card chip
(contactless) 0.030 to 0.050 inches 0.762 to 1.27 mm
Thickness with
smart card chip
(contact) 0.030 to 0.040 inches 0.762 to 1.016 mm
Thickness with
mag stripe, not
laminated 0.020 to 0.040 inches 0.508 to 1.016 mm
Thickness with
mag stripe,
laminated SP75 only:
0.030 to 0.040 inches
0.762 to 1.016 mm
Thickness for
printing and
laminating SP75 only:
0.030 to 0.050 inches
0.762 to 1.27 mm
Thickness for
printing only SP35, SP55:
0.010 to 0.050 inches
SP75:
0.020 to 0.050 inches
0.254 to 1.27 mm
0.508 to 1.27 mm