Data Translation DT351, Руководство по началу работы

Страница: 31 / 52

Loading and Configuring the Device Driver
23
4
4
4
4
4
4
4
4
4
Configuring the Device Driver
To configure the device driver, perform the following steps:
1. If you have not already done so, power up the host computer and
all peripherals.
2. From the Control Panel, double-click the Open Layers Data
Acquisition Control Panel
icon.
The Open Layers dialog box appears.
3. Click the DT351 board that you want to configure, then click
Advanced
.
The DT351 Control Panel dialog box appears.
4. Check the bits of the digital input that you want to generate an
interrupt when the bit changes state, where bit 0 corresponds to
digital input line 0 and bit 7 corresponds to digital input line 7.
Refer to Chapter 2 of the DT351 User’s Manual for more
information on interrupts.
5. Click OK.
6. If you want to rename the board, click Edit Name; otherwise, go
to step 8.
Note: Each module must have a unique name. This name is
used to identify the module in all subsequent applications.
7. Enter a new name for the board, then click OK.
8.
When you are finished configuring the board, click Close.