Data Translation DT3153, Руководство по началу работы

Страница: 46 / 64

Chapter 5
38
g. Browse to the Drivers\DT3153\Win98 directory on the
Imaging OMNI CD, then click OK .
h. Click Next .
i. Click Next .
j. Click Finish .
A dialog box appears prompting you to restart your system.
3. Remove the CD-ROM from the CD-ROM drive, then click Yes .
After the system restarts, a dialog box appears prompting you to
configure the driver.
4. Click OK , then click OK .
5. Click Add New to add a DT3153 board.
The DT3153 Installation dialog box appears for the new board.
6. Enter any unique name (or alias) for the DT3153 board, then click
Add . Only one alias per installed board is allowed.
The DT3153 Configuration dialog box appears.
7. Select Enable Board to activate the board. If you want to retain
the settings but disable the board (and therefore not use the
memory), remove the checkmark next to Enable Board.
8. Select the Video Format as either 50 Hz or 60 Hz.
9. For Desired Memory Size , select the amount of contiguous
memory (in MB) that you want to allocate in your system to hold
the acquired frames. A 60 Hz, 640-by-480 image requires 1.2 MB
per frame; a 50 Hz, 768-by-576 image requires 1.7 MB per frame.
The actual amount of memory that the device driver can allocate
depends on your system resources. It is recommended that you
select only as much memory as you need to leave memory for
other devices. Once you enter the desired memory size, the
device driver allocates as much memory as possible to match the
value you entered; the actual memory size allocated is shown in
the
Actual Memory Size text box when you restart your system.