Chapter 6
66
Performing an Area-Scan Operation
To synchronously acquire a single frame to memory, perform the
following steps:
1.
Connect video input signals to input channel 0 (VID0).
2.
From the DT-Acquire main menu, click
Setup
, then click
Select
Device
.
3.
Select the alias that you gave to the DT3152-LS board when you
configured the device driver, then click
OK
.
4.
To get started, leave the remainder of the settings under
Setup
at
their default values.
5.
From the DT-Acquire main menu, click
Run
, then
Single Frame
Acquire!
.
A single frame is acquired (synchronously) and displayed on the screen.
6.
To acquire another frame, repeat step 5.
7.
If you wish, modify the parameters available for the DT3152-LS
board by clicking the desired parameter under
Setup,
and
changing the associated values, then repeat step 5.
Note:
If you change the video input source, ensure that you
connect the video input signals to the corresponding channel.
8.
If you wish, save the graphic by clicking
File
from the
DT-Acquire main menu, then
Save Graphic File
.
9.
When you are finished with this utility, from the DT-Acquire
main menu, click
Setup
, and
Close Device
. Then, close the
application.
Содержание DT3152-LS
