Data Translation DT3152-LS, Руководство по началу работы, Страница: 50 / 84

Chapter 5
40
13. Click Yes to restart the system.
For proper operation, it is very important that you restart Windows 95
when prompted.
14. If a Windows 95 Shutdown dialog box appears, manually close
all open applications on your desktop, then click
OK to continue.
Otherwise, the system restarts.
When the system restarts, a dialog box appears prompting you to
initiate the Configuration Utility.
15. Click OK to initiate the Configuration Utility.
Note that it is not necessary to log in to your network to run the
Configuration Utility.
16. Click OK to begin configuring the DT3152-LS board.
17. Follow the steps on page 40 to add the new DT3152-LS board to
the DT3152-LS Device Driver configuration.
Adding a Board using the Configuration Utility
To add a new DT3152-LS board to the DT3152-LS Device Driver
configuration at system startup, perform the following steps:
1. Click Add New to add a DT3152-LS board.
The DT3152-LS Installation dialog box appears for the new board.
2. Enter a board name (alias), which can be any name you choose,
then click
Add . (The board name is used by supported software,
such as DT-Acquire and the Frame Grabber SDK.) Only one
name (alias) per installed board is allowed.
The DT3152-LS Configuration dialog box appears.
3. On the General tab of the DT3152LS Configuration dialog box,
click Enable Board to activate the board.
If you want to retain the settings but disable the board, remove the
checkmark next to Enable Board.