Data Translation DT3130 Series, Руководство по началу работы

Страница: 34 / 54

Chapter 4
26
Connecting Video Signals to the Board Using the
EP311 Cable
If you purchased the optional EP311 cable, you can connect up to
three simultaneous monochrome/composite video signals, which use
the NTSC/RS-170 or PAL/CCIR video format, to connector J2 on the
DT3130 Series board, by performing the following steps:
1. After making sure power to the computer is off, push the 15-pin
connector of a EP311 cable into the J2 socket at the rear of the
DT3130 Series, as shown in
Figure 3 , then tighten the screws on
the connector.
Figure 3: Connecting the EP311 Cable to Connector J2
CAUTION:
Always turn off the power to both your computer and the video
source before making these connections. Damage can result if
connections are made with the power on.
J1
VID3
VID6
VID0
EP311
J2
P3
DT3130 Series
Board