Data-Linc Group FLC830E, Руководство пользователя

Страница: 10 / 31

10
PN 161-11907-004
May 2014
FLC830E / FLC910E User’s Guide
Setting up a system
Basic Setup:
In the basic setup menu you have the option to set a
different wireless device name then the default, which is
DEVICExxxxxx, where the xx is a hexadecimal number
related to last 6 digits of the MAC address.
For a system the IP Addresses on the units must be unique
and use the same IP Subnet Mask. After changing the IP
Address, the PC IP address may have to change to be on
the same network to continue configuration.
Operating modes (Radio Settings):
The FLC830E/910E can operate as a base station, station
adaptor, wireless repeater, or in wireless interbuilding mode
to create a wireless network. The following with describe the
setup of each type of unit and the connectivity between the
units.
Base Station:
The “Base Station” operates as the central unit for the
connectivity. “Station Adaptors” and “Wireless Repeaters”
will connect and communicate with a “Base Station”.
To setup the “Base Station” select “Base Station” from the
drop down menu of “Operating Mode”.
Apply this setting; the unit will be in base station mode.
Select the type of modulation OFDM or CCK.
Select the data rate to use. Note: Best will try to establish
the highest possible data rate, but for longer distances using
a fixed lower rate may improve system reliability.
Select the output power, from full – min depending on
distance.
Select the bandwidth to use. The bandwidth selected will
determine the usable channels / frequency.
Select the Channel to use based on the table below:
Bandwidth FLC830E Ch. Available FLC910E Ch. Available
20 MHz CH1 thru CH11 CH2 or CH3
10 MHz CH1 thru CH11 CH1, CH2, CH3, or CH4
5 MHz CH1 thru CH11 CH1, CH2, CH3, or CH4
Apply the setting changes, if any.