INSTALLATION
1.
LOCATE A GOOD SPOT ON YOUR WALL
(PREFERABLY CLOSE TO AN ELECTRICAL
OUTLET).
4.
USE A STUD FINDER TO FIND THE STUDS IN
THE WALL, THEN MARK THE WALL ABOVE THE
PANEL INDICATING WHERE THE STUDS ARE.
7.
ONCE THE FIRST SCREW IS IN YOU CAN PLACE
A LEVEL (OR YOUR PHONE IF YOU HAVE A LEVEL
APP) ON THE TOP EDGE OF THE PANEL. CHECK
TO MAKE SURE THE PANEL IS PERFECTLY LEVEL...
ADJUST AS NEEDED.
2.
PLACE THE INSTALLATION SPACER ON THE
FLOOR IN AN UPRIGHT POSITION LEANING
AGAINST THE WALL AT THE MIDPOINT OF
WHERE YOUR PANEL WILL GO.
5.
IN THE TOP LINE OF HOLES ON THE PANEL,
IDENTIFY A HOLE THAT CORRESPONDS WITH A
STUD.
8.
ONCE THE PANEL IS LEVEL, IDENTIFY OTHER
HOLES THAT LINE UP WITH STUDS AND SCREW
IN FASTENERS. MINIMUM OF EIGHT FASTENERS
INTO STUDS RECOMMENDED.
3.
PLACE THE MIDDLE LINE OF THE PANEL ON
THE SPACER AND PRESS PANEL FLAT AGAINST
WALL.
6.
SCREW IN A FASTENER THROUGH THAT HOLE.
MAKE SURE THE HEAD OF THE FASTENER IS
FLUSH WITH THE WOOD, OR SLIGHTLY SUNKEN.
9.
REMOVE SPACER. FOR ADDITIONAL
FASTENING NOT INTO A STUD, FOUR RED WALL
ANCHORS ARE ALSO INCLUDED WITH KIT.
WALL STUDS
MAKE SURE AT LEAST
40” OF UNINTERUPTED
WIDTH AVAILABLE
MIDDLE LINE
