2.4GHz FHHS DIGITAL Transmitter/Receiver
MODEL: DA911W
USA VERSION
DASAN Electron
PREPARING FOR INITIAL USE
1.
setting the Battery on transmitter.
2.
Ensure that the Li-ion battery is installed and fully charged before initial use.
3.
Check line and power connections.
4.
Push the transmitter TALK button to confirm. If you do not get a LED display, please refer to the
Troubleshooting chart.
OPERATION
5.
Supply 12 VDC power into the BASE using the provided AC adaptor.
6.
Separate the transmitter from the BASE and turn on the transmitter.
7.
Push the TALK button on the transmitter. When the antenna icon on the LED of the transmitter is
displayed steadily, the communication channel between the BASE and transmitter has been setup and
the transmitter is transmitting the audio signal. On the other hand, when the antenna icon blinks, the
frequency channel between the BASE and transmitter does not match. Place the transmitter in its cradle
on the BASE. Put Transmitter on the Receiver (Charging). Press and hold
TR's talk button over 5 secs. Unhold the talk button. The TR+RE' Green LED is blinking 5 times
and will be heard a confirm tone. the communication channel has been setup and the transmitter
is ready to operate normally.
8.
When the antenna icon is displayed on the LED window of the transmitter by pressing the toggling
TALK button, the transmitter is transmitting the audio signal and the BASE outputs the active-high
digital signal on the talk-mode output pin.
9.
When the active-low digital signal exists on the video-on input pin of the BASE, a recorder icon is
displayed on the LED window of the transmitter.
10.
When the distance between the BASE and transmitter is within the coverage area, both the recorder and
antenna icons are displayed steadily by providing the video-on signal on the BASE. On the other hand,
when the distance between the BASE and transmitter is out of the coverage area, the recorder icon turns
off and the antenna icon blinks.
11.
When recording is finished, turn off the transmitter and place it in its cradle on the BASE for charging.
TROUBLE SHOOTING
SYMTPOM SOLUTION
No recording sign
♦
Check for the line cord connectors at both ends that they are pushed in firmly until they
click.(docking & recorder)
♦
IF you had a power failure or had unplugged the docking station, replace the transmitter
on the docking station for two to five seconds to reset the system.
No power on the
transmitter unit
♦
Check the Ni-MH battery pack connection inside the battery compartment on the
transmitter.
♦
The transmitter rechargeable Li-ion battery pack may need to be charged.
Does not charge
♦
Make sure the charging contacts on both the docking station and the transmitter are in
