DarwinFPV HULK, Руководство пользователя, Страница: 7 / 8

AIO can enter DFU Mode in two ways:
1. Connect to computer by USB-C cable, open the Betafight software and click “connect”
button, turn on “Expert Mode” at the top of the page, then disconnect and reconnect, click
Setup menu - Activate Boot Loader/DFU menu, you are now in DFU Mode. (If you are
automatically connected, the steps are similar to manual connection, example with
Betaflight 10.8.0).
② Connect to computer by USB-C cable, open the Betafight software and click connect
button - CLI menu, entering "BL" in the menu bar can also enter DFU Mode (“BL”can be
uppercase or lowercase).
RC LED Status Receiver Mode
Green Light Stays On Paired
Green Light Fast
Flashing
In Pairing Mode
Green Light Slow
Flashing
Not Paired
售 后 服 务
PAIRING
售 后 服 务
How to enter DFU Mode
Connect to computer by USB-C cable, open the Betafight software and click
“connect” button, enter the receiver configure page, and click "Bind Receiver"
button. At the same time, the green receiver led indicator (I.E. “RC LED”) will
change from slow flashing to fast flashing, indicating that the receiver has entered
pairing mode.
Reminder: After the pairing is successful, the led indicator will change from fast
flashing to slow flashing, indicating that the pairing is successful, after a while, the
indicator light will turn steady on, indicating that the connection is successful. After
1st pairing, the receiver will remember the pairing info. In the future, every time the
drone is powered on, it will automatically connect & no need to rebind.
Betaflight 4.3 firmware only supports ELRS_V2.x TX Module.