Darwin Fitness EVO40, Руководство по сборке и эксплуатации

Страница: 20 / 36

EVO40
20
3.2 Turn On and Turn Off the Device
1. Turn on POWER
LCD shows all segments. (see fig.)
2. Turn Off POWER
If no signal is transmitted to the console for 4 minutes, the
console is going into sleep mode.
3.3 Training Settings
1. To choose the function TIME, DISTANCE, CALORIES and
PULSE, press MODE/ENTER.
2. Make adjustments with the button SET and apply the
settings with the button MODE/ENTER.
Example:
Setting the time - If the time value blinks, you can adjust the number with the SET button. After
applying the settings with MODE/ENTER you get to the next setting. The setting for DISTANCE,
CALORIES and PULSE takes place identical.
As soon as the training starts and the console is receiving training signals, the values for
SPEED/RPM, TIME, DST and CAL will be counted up on the display.
3.4 Recovery
The RECOVERY button works only, if a pulse signal is received.
TIME shows 0:60 (seconds) and counts backward to 0:00. After the countdown
the console shows F1 to F6, to check the heart rate status.
For classification see the table.
1. To get back to the start, press RECOVERY again.
3.5 Troubleshooting
If the display of the LCD is milky, the batteries should be changed.
If no signal occurs when you press the pedals, check the wiring of the cable.
L
NOTICE
+ If you interrupt your training for 4 minutes, the main display turns off.
+ If the console display is abnormal, reinsert the batteries and try again.
F1 Very good
F2 Good
F3 Average
F4 Adequate
F5 Below Average
F6 Inadequate