Dartek PED 02-10, Инструкция по эксплуатации товара

Страница: 4 / 6

Trigger Switch
Reverse Switch
Lever
Only push the trigger switch when starting the tool. The
greater the pressure applied on the trigger switch, the
faster the tool speed. Release the trigger switch to stop
the tool.
For continuous operation, push the trigger switch and
then press the lock button.
Push the trigger switch to the end and then release it
to stop the tool from the locked position.
Put the bit tip on the screw head and apply
appropriate pressure to the machine. Start the
machine slowly, and then gradually increase the
speed. The screw can be tightened when the
machine rotates clockwise, and the screw can be
removed when the machine rotates counterclock-
wise.
Note:
The direction of rotation be changed only when the
machine completely stops rotating, otherwise the
machine will be damaged; make sure to confirm
that the bit is inserted vertically into the screw head,
otherwise the screw or bit may be damaged.
When tightening the wood screws, drill a middle
hole first to make the screwing operation easier and
prevent the workpiece from sliding.
Refer to the following table.
Wood Screw Nominal
Diameter (mm)
3.1
3.5
3.8
4.5
4.8
5.1
5.5
5.8
6.1 2.0-2.2
2.2-2.5
2.5-2.8
2.9-3.2
3.1-3.4
3.3-3.6
3.7-3.9
4.0-4.2
4.2-4.4
Recommended Middle
Hole Diameter (mm)
This tool is equipped with a reverse switch to change
the direction of rotation. The tool rotates clockwise
when the reverse switch lever is pushed to (Side A);
the tool rotates counterclockwise when the reverse
switch lever is pushed to (Side B).
Only hold the tool handle during operation.
Note:
• Make sure to confirm the direction of rotation before
operation.
• Make sure to use the reverse switch after the tool is
completely stopped. The tool may be damaged if the
direction of rotation is changed before the tool has
stopped.
Note:
• The drill speed cannot be increased by firmly
holding the tool. Actually
，
the drill bit can be
damaged by this excessive pressure, which is not
benefit for the tool operation and will reduce the
tool life.
• A great force is generated on the tool/drill when the
holes is drilled through. Therefore, hold the tool
tightly and be more careful when starting to drill
holes through the workpiece.
• Make sure to clamp the small workpiece with a
vise or similar clamping device.
Lock Button
Operate the reverse switch
Screw tightly
Hold the tool
Drill holes in the wooden plate
The woodworking drill of lead screw is used when
drilling holes in the wooden plate. It is helpful to
drill the plate by using this lead screw.
Drill holes in the metal plate
A sharp punch and hammer can be used to make
a mark on the metal plate where you want to drill,
in order to prevent the drill bit from slipping when
starting to drill. Then drill holes by using the drill bit
aligned with the mark.
The lubricating oil is used when drilling holes in the
metal. But the lubricating oil is not required when
drilling the steel and brass plate.
Drilling operation
Bit Tip
Bit
Screw Head