Darling BDGR24NG, Инструкция по эксплуатации

Страница: 3 / 11

March 2016
CODES AND STANDARDS
This item must be installed in accordance with:
In the United States:
State and local codes, or in the absence of local codes, with:
National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition). Copies may be obtained from The American Gas
Association Accredited Standards Committee Z223, @ 400 N. Capital St. NW, Washington, DC 20001 or the Secretary
Standards Council, NFPA, 1 Batterymarch Park Quincy, MA 02169-7471.
NFPA Standard #96 Vapor Removal from Cooking Equipment, latest edition, available from the National Fire Protection
Association, Batterymarch Park, Quincy, MA. In the commonwealth of Massachusetts all gas appliances vented through
a ventilation hood or exhaust system with a damper or with a power means of exhaust shall comply with 248 CMR.
In Canada:
Local codes:
CAN/CSA-B149.1 Natural Gas Installation (latest edition).
CAN/CSA-B149.2 Propane Installation Code (latest edition), available from the Canadian Gas Association 178 Rexdale
Blvd., Etobicoke, Ontario Canada M9W 1R3.
The installer of this unit should be aware of state, county or local code for connecting this equipment to determine if an
external regulator is required
OPERATING INSTRUCTIONS AND CONTROLS
When turning on for the fi rst time please be advised that it might take a little longer to ignite due to the air existing in the
pipe. If the ignition does not light, turn off the ignition switch and wait 3 minutes to try again.
BURNERS
1. Connect the gas supply and ignite the pilot fl ame with a lighter. If the unit hasn’t been used in a while or if this is the
fi rst lighting, ignition might take a little longer (about two or three minutes).
2. Press the corresponding valve knob of burner and turn 90 degrees counterclockwise. The burner will be ignited. If “
” on the knob is aligned with the round dot on the panel, the fl ame is Max. To set the fl ame to Min, rotate
counterclockwise to the Min fl ame position. “ ” is Min.
3. When fi nished turn off main burner by rotating the knob clockwise to off position .