6
I N S T R U C T I O N M A N U A L
Step 5
Insert the trigger lock spreader pole into one of the centre eyelets. Release the trigger to extend the pole and insert
into one of the end eyelets. Tension the bar to stretch the swag into shape then lock into position. Repeat this
process for the other spreader pole. The guy ropes and pegs can be used if required.
Now your Dirty Dee swag set up is complete.
PACK DOWN
1. Partially close all the zips, door covers and window flaps, leaving them slightly open will allow for the air to
escape while rolling up. Remove pegs and guy ropes if used.
2. Release the trigger of the spreader poles and remove them from the eyelets.
3. Unclip the swag from the composite poles one at a time.
4. Disassemble all of the poles in preparation for step 5 below.
5. While the swag is laid out flat, bring any overhanging canvas and ropes into the centre of the swag. Beginning
from the head end, start rolling the swag as tightly as possible in an attempt to expel as much air as possible
to achieve a compact roll. Tip: Using your knees, or two people while rolling, will assist in getting the swag as
compact as possible. Just before completing the rolling process, place all the disassembled poles between the
fabric and continue the rolling process to the end.
6. Bring the two compression straps together and loop through the double D-rings, do not over tighten the straps.
