6
Installation
Remove all packing materials from the ZoneControl MKII. Check that all foam and plastic padding is
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
1. GAIN
Mic Channel input level is determined by the Gain control.
With the Gain control you can adjust the MIC input-sensitivity, while optimally
matching the incoming signals to the mixer’s internal operation level. When dealing
with very low input levels (example vocal recordings or distant sound sources) the
high gain is extremely profitable.
How to set the Input level:
1)
Set the gain control and the corresponding channel fader to their minimum setting.
2)
Connect the desired sound source (CD player, microphone, ect) to the
corresponding MIC input.
3)
Play the sound source at its highest volume setting; respectively, sing or speak as
loud as possible directly into the microphone.
4)
While doing so, adjust the input level using the gain control, so that during the
loudest passages the PEAK LED is just not lit, but the SIGNAL-LED lights
constantly.
This basic channel setting leaves you at least 8dB headroom. This means, you have
at least 8dB before signal clipping. If you want to make further adjustments to the
channel’s EQ setting, you should repeat step
3
and
4
again.
2 / 3 / 4. EQ HIGH / MID / LOW
The mixer’s Equalizer section allows shaping of the incoming audio signal. All mono
input channels are fitted with 3-band EQ. The upper (
2
) and lower (
4
) shelving
controls have their frequencies fixed at 12 Khz and 80 Hz respectively. The Mid range
control (
3
) has a peaking response frequency at 2.5 Khz. All 3 bands have up to 12
dB cut and boost, with a centre detent for “OFF”. Turning the Equalizer level control to
the right amplifies the frequency range, turning to the left attenuates the signal. Minor
changes to the Equalizer control usually produce the best results. Try to avoid
excessive enhancement of the MID band.
5. PAN
By using the PAN control you can change the input signal’s position within the stereo
image. When the PAN control is set to center position, the audio signal is equal for
both the left and right buss.
Содержание ZoneControl MKII
Страница 1: ...ZoneControl MKII ORDERCODE D2107...
Страница 15: ...2005 DapAudio...
