DAPAudio WCS-46, Руководство пользователя

Страница: 6 / 8

Ordercode: D6577
WCS-46
Installation
01) Drill a hole in the ceiling, big enough to fit the speaker (Ø 125 mm).
02) Connect the black cable to the common cable.
03) Connect one of the 2 colored cables to the main feed cable: white cable = 6W, green cable = 3W.
04) Insert the speaker into the hole on the ceiling and secure it by means of the clamps.
Fig. 01
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
Sound Warping
If the sound coming out of your speaker is loud enough, but seems to be warped or distorted, your treble
or bass levels may need to be adjusted.
If there are not many pieces of furniture in the room and the floor has no carpet or rug, then you will most
likely have to set your treble to minus. With very little in the room to absorb the sound, too much treble
can make the sound bounce off of fixtures in the room, making it tinny sounding.
With the bass, if the speaker is too close to a wall and is not aimed properly, then you will need to set the
bass to minus, to stop the low tones from bouncing off of the walls or large pieces of furniture.
5