DAPAudio TAS-2400, Руководство пользователя

Страница: 9 / 18

7
Backpanel
Fig. 3
18. Power Fuse.
Replace the fuse only by a fuse of the same type (T18A, 6x32mm).
19. Input Sensitivity Selector.
This selector allows you, to choose the input sensitivity: -26dB, -32dB or -38dB.
20. Mains Cord
Connect to the mains.
21. Air cooling windows
Make sure these outlets remain clear to allow unrestricted air flow.
22. Mode Selection Switch.
This recessed, three-position switch configures the amplifier for Stereo, Parallel or Bridged Mono Mode
operation. Amplifiers are factory configured for Stereo Mode. Also see Mode selection on page 8.
23. Balanced Link Out connectors.
Used to Link the input signals to other amplifiers.
24. Balanced XLR Input Connectors.
These connectors accept input signals on XLR input plugs, See the section on connecting cables on
page 11/12 for information on polarity, Connectors for each channel are in parallel, The unused
connectors may be used for linking to other amplifiers.
25. Output terminal Connectors.
Using speaker cables, make connections to both the channel A and channel B connectors for Stereo
or Parallel mode, use the red terminals only for Bridged mono mode.
26. Output Speakon Connectors.
Use either the speakon connectors or the terminals. Using the speakon connectors, make connections
to both the channel A and channel B connectors for Stereo or Parallel mode, use only the channel A
connector for Bridged mono mode. Using the terminals, make connections to both the channel A
and channel B terminals for Stereo or Parallel mode, In bridged mono mode use only the red
terminals. For more information see page 9 and 10.