DAPAudio Sessionmix 8, Руководство по эксплуатации продукта

Страница: 14 / 19

12
25. Aux 1 returns
Use these stereo inputs in combination with
the Aux 1 send to connect an external effect
device.
26. Aux 2 returns
Use these stereo inputs in combination with
the Aux 2 send to connect an external effect
device.
Fig. 10
27. Phone out
You can connect a pair of headphones with a minimum impedance of 32 Ohm to this stereo 1 /4” jack
should be wired as Tip=left, Ring=right and sleeve=ground.
28. Tape in stereo RCA
29. Tape out stereo RCA
30. Aux 1send
Use this output in combination with the Aux 1 returns to connect an external effect device.
31. Aux 2 send
Use this output in combination with the Aux 2 returns to connect an external effect device.
Fig. 11
32. Power On/Off
Do not supply power before the whole system is set up and connected properly.
33. Remote Power Supply Input Socket
This is the remote AC power supply input socket for the Sessionmix. It is a special three core socket.
Please use the supplied DAP audio adapter only.
34. Phantom Power Switch
Press this button to turn the phantom power +48V on. Do not connect any unbalanced microphones with
the phantom power switched on. The red Phantom LED (15) will light if the phantom power is activated.
35. Main out R balanced
36. Main out L balanced
37. Main out L/R unbalanced
38. Control room out stereo unbalanced
64. Channel 1-4 insert
Insert for external device, effect, compressor etc. It provides an output of the channels at line-level. At
the same time the inserts have an input at line level from where the signal is further routed through the
channels equalizer and so forth. When not in use (unplugged), input and output are connected to
provide normal signal flow in that channel.