DAPAudio SCS-230, Руководство пользователя

Страница: 7 / 12

Ordercode: D6612
SCS-230
Installation
Remove all packing materials from the SCS-230. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Remove the screws from the bottom side of the SCS-230 to gain access to the cables and connectors.
Fig. 02
100V Mode
01) Connect the black cable to the common cable.
02) Connect one of the colored cables to the main feed cable: thick red cable = 30W, yellow cable =
15W, green cable = 7,5W.
Conventional Amplifier Mode
01) Connect the black cable to the common cable.
02) Remove the cable bridge between the white and the thin red cable.
03) Connect the thin red cable to the main feed cable.
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
Sound Warping
If the sound coming out of your speaker is loud enough, but seems to be warped or distorted, your treble
or bass levels may need to be adjusted.
If there are not many pieces of furniture in the room and the floor has no carpet or rug, then you will most
likely have to set your treble to minus. With very little in the room to absorb the sound, too much treble
can make the sound bounce off of fixtures in the room, making it tinny sounding.
With the bass, if the speaker is too close to a wall and is not aimed properly, then you will need to set the
bass to minus, to stop the low tones from bouncing off of the walls or large pieces of furniture.
6