DAPAudio PSS-110 MKIII, Руководство пользователя

Страница: 13 / 24

12
PSS-110 MKIII
Ordercode: D2611
Inserting/Replacing the Microphone Battery
Fig. 06 Fig. 07
01)
Turn the battery cover clockwise, in order to loosen it. Remove the battery cover (Fig. 06).
02) Pull upwards on the holding pin and, at the same time, pull the battery holder down, in order to gain
access to the battery housing (Fig. 07).
03) Insert 2 AA (LR 6) batteries into the battery housing, paying attention to the polarity markings (+/-).
04) Close the battery housing and replace the battery cover. Tighten the battery cover by turning it
counterclockwise.
Adjusting Input Gain
Fig. 08 Fig. 09
01)
Turn the battery cover clockwise, in order to loosen it. Remove the battery cover (Fig. 08).
02) Use the included plastic screwdriver (43) to set the transmitter’s input sensitivity (Fig. 09).
03) Close the battery housing and replace the battery cover. Tighten the battery cover by turning it
counterclockwise.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. The power supply is printed on the back of the device.
Do not attempt to operate an 115V specification product on 230V power, or vice versa.
Connection
01) Set the power switch (12) to OFF position, in order to turn the PSS off.
02) Connect the PSS to the other devices which you plan to use.
CAUTION: Make sure that the power is off, when connecting the cables.