DAPAudio PSS-110 MKIII, Руководство пользователя

Страница: 14 / 24

13
PSS-110 MKIII
Ordercode: D2611
Battery Operation
01) When the battery level indicator (35) lights up red, the battery is almost flat and needs to be
recharged.
02) Make sure that the power switch (12) is in OFF position and plug one end of the included IEC to
Schuko power cable into the IEC input connector (13). Plug the other end into an appropriate power
supply.
03) Set the power switch (12) to RECHARGE position.
04) Observe the recharge indicator (37). While recharging, the indicator will light up red. When the
battery is fully charged, it will light up green.
05) Unplug the IEC to Schuko power cable. If the battery is fully charged, the PSS can run on battery
power for approximately 3 hours, depending on the volume level.
Note:
The battery in the PSS should not be fully depleted. Charge it when it is low, but do not let it drain fully.
On the other hand, constant top-off charging of a battery is never good.
Any charging adds heat which degrades a battery. Storage in a cool place slows the aging process of
lithium-ion. Manufacturers recommend storage temperatures of 15°C.
Microphone Operation
01) Turn the PSS on by setting the power switch (12) to ON position.
02) Turn the microphone on by pressing and holding down the power/mute switch (40) for 3 seconds.
The LED status indicator (39) will light up green.
03) Press the UP/DOWN buttons (05/07) in order to choose one of the 100 channels (see page 15 for the
frequency range chart). Alternatively, press and hold down the UP button (05) for 6 seconds, for
quick channel search. The display (09) will show:
04) Once you have chosen a channel, press and hold down the UP button (05) for 3 seconds. The
currently chosen channel’s number will start blinking.
05) Remove the battery cover (Fig. 10). Otherwise it will not be possible to pair the devices.
06) Place the microphone’s IR sensor (41) close to the display (09), in order to pair the speaker with the
microphone (Fig. 11).
Fig. 10 Fig. 11