DAPAudio PSS-110 MKII, Руководство пользователя

Страница: 13 / 16

Ordercode: D2609
PSS-110 MKII
01) Press the cover (1) down, in the direction of the arrow.
02) Slide the cover (2) in the direction of the arrow.
03) Insert the battery. Please mind the correct polarity when inserting the batteries.
04) Close the battery cover.
Tips For Achieving Maximum Performance
• Make sure you can always see the receiver antenna from the transmitter position.
•
Keep the distance between the transmitter and the receiver antenna as short as possible.
• Point the receiver antennas away from each other, at an angle of 45° from vertical position.
•
Avoid placing the receiver antennas near metal surfaces and obstructions.
•
Replace the battery as soon as the low battery indicator LED lights up.
• Perform a walk-through before performance or presentation. If dead spots are found, adjust the
location of the receiver. If dead spots remain, mark the dead spots and avoid them.
Maintenance
The DAP Audio PSS-110 MKII requires almost no maintenance.
However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp
cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Replacing the Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens, follow the directions below.
01) Unplug the unit from electric power source.
02) Insert a screwdriver into the slot in the fuse cover. Gently pry up the fuse cover. The fuse will come
out.
03) Remove the used fuse. If brown or unclear, it is burned out.
04) Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
If the speakers do not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the speakers, the fuse.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The speakers. Return the PSS-110 MKII to your DAP Audio dealer.
03) The fuse. Replace the fuse. See page 12 for replacing the fuse.
04) If all of the above appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the PSS-110 MKII, as this may
damage the unit and the warranty will become void.
06) Return the device to your DAP Audio dealer.
12