11
63. 70V terminal
Connect this terminal to the + terminal of your 70V speaker(s). In case of using several speakers make
sure all speakers are wired in parallel.
The total power rating of the 70V-speakers connected to this terminal summed should never exceed 80W.
64. 100V terminal
Connect this terminal to the + terminal of your 100V speaker(s). In case of using several speakers make
sure all speakers are wired in parallel.
The total power rating of the 100V-speakers connected to this terminal summed should never exceed
80W.
65. AM Antenna connector
Connect your AM antenna to this connector
66.
GND Screw
This screw offers a separate ground connection. Can be useful in case of grounding problems.
67. Fan
Do not obstruct the air inlet.
Operation
Installation
Remove all packing materials from the PA-805CDTU. Check that all foam and plastic padding is
removed. Secure the equipment into a 19" rack if prefered. Connect all cables.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate an 115V specification product on 230V power, or vice versa.
Before powering up the first time, make sure the AC-selector switch is set to the proper voltage.
Damage caused by connecting the amplifier to improper AC voltage is not covered by any warranty.
NOTE: Always turn off and disconnect the amplifier from mains voltage before making audio
connections. Also, as an extra precaution, have the attenuators turned down during power
-up.
Connecting Inputs
Use the jack inputs at the front or the XLR input connectors on the rear to supply audio signals to your DAP
Audio PA-Series amplifier. The jack connectors accept unbalanced audio connections while the XLR
connectors accept balanced and unbalanced audio connections. (The PA- Series amplifiers are
configured standard with "Pin 2 hot" on XLR inputs. For more Information, see the section on Connection
cables on page 15.
Operating the Tuner
Selecting a station
Use the
AM/FM (15)
button to select either AM or FM band. Press the
(20)
or
(21)
button to tune
stepwise.
Pushing and holding the
(20)
or
(21)
button for more than 3 seconds will start auto search.
Selecting a preset.
Use the
AM/FM (15)
button to select either AM or FM band.
Press
M1
(16)
,
M2 (17)
,
M3 (24)
,
M4 (27)
or
M5 (29)
to recall preset M1-M5.
