DAPAudio MHS-50S, Руководство пользователя

Страница: 7 / 12

Ordercode: D6545
MHS-50S
02) Set the desired output volume. Connect the white and black cable to the appropriate connectors
(1-5). For example, to set the device to 9W, you need to connect the white and black cable to the
(1) Red and (3) Green connectors. For more information, see the sticker on the rear side of the
device .
Fig. 02
03) Replace the rear panel and tighten the screw.
04) Connect the power supply to the speaker. Connect the main feed cable to the white cable (+) and
the common cable to the black cable (-).
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
Sound Warping
If the sound coming out of your speaker is loud enough, but seems to be warped or distorted, your treble
or bass levels may need to be adjusted.
If there are not many pieces of furniture in the room and the floor has no carpet or rug, then you will most
likely have to set your treble to minus. With very little in the room to absorb the sound, too much treble
can make the sound bounce off of fixtures in the room, making it tinny sounding.
With the bass, if the speaker is too close to a wall and is not aimed properly, then you will need to set the
bass to minus, to stop the low tones from bouncing off of the walls or large pieces of furniture.
6