7
7.
Priority button
Pushing this button allows you to switch the priority function for channel 1 on or off. If the priority function
is active, all channels except channel 1 will be muted when the
mic 1 (11)
input picks up a signal.
8.
Chime button
If pushed in, the device enters chime mode. In chime mode, the chime signal will be activated and all
inputs except input 1 will be muted so you are able to broadcast a message after the chime signal.
9. Zone signal LED’s
The signal LED indicates that there’s an audio signal present at the output of the corresponding zone.
10. Power LED
Indicates the amplifier is turned on.
11. Mic input
Use to connect a microphone.
12. Zone assign buttons
Use to assign a channel to one or more zones.
13. Tuner/media player
See the next paragraph.
14. Headphone output
You can connect a pair of headphones with a minimum impedance of 32 Ohm to this stereo 1/4” jack.
The jack should be wired as Tip=left, Ring=right and sleeve=ground.
15. Monitor buttons
Allows you to monitor one or more zones with your headphone.
16.
Aux input
3,5mm stereo mini jack input for connecting a line level device such as an I-pod, CD player etc.
17. AC power switch
This is the main Power switch. Push to turn the amplifier on.
Tuner/media player
Fig. 2
18. AM/FM radio selection button
MP3 mode: Pushing this button allows you to enter tuner mode.
Tuner mode: Pushing this button allows you to select either the AM band or the FM band.
19. USB/SD (M1) button
MP3 mode: Pushing this button lets you select between USB or SD player mode.
Tuner mode: Pushing this button will recall memory preset M1.
