DAPAudio IPS-PA600, Руководство по эксплуатации продукта

Страница: 7 / 13

5
Backpanel
Fig. 2
12. Auto Fuse.
13. Common terminal.
Connect this terminal with the – terminal of your speaker(s).
14. 4
Ω
terminal.
Connect this terminal to the + terminal of your 4
Ω
speaker(s). In case of using several speakers make
sure that the total speaker load is 4
Ω
. The total power rating of the low impedance speakers should
be at least 600W.
15. 8
Ω
terminal.
Connect this terminal to the + terminal of your 8
Ω
speaker(s). In case of using several speakers make
sure that the total speaker load is 8
Ω
. The total power rating of the low impedance speakers should
be at least 600W.
16. 70V terminal.
Connect this terminal to the + terminal of your 70V speaker(s). In case of using several speakers make
sure all speakers are wired in parallel.
The total power rating of the 100V-speakers should never
exceed 600W.
17. 100V terminal.
Connect this terminal to the + terminal of your 100V speaker(s). In case of using several speakers
make sure all speakers are wired in parallel. The total power rating of the 100V-speakers should never
exceed 600W.
18. Mains Cord
Connect to the mains.
19. Balanced XLR Input Connector.
These connectors accept input signals on XLR input plugs, See the section on connecting cables on
page 8/9 for information on polarity.
20. Unbalanced Jack Input Connector.
These connectors accept input signals on XLR input plugs, See the section on connecting cables on
page 8/9 for information on polarity.
21. Balanced Link Out connector.
Used to Link the input signals to other amplifiers.
22. Unbalanced Jack Link Out Connector.
Used to Link the input signals to other amplifiers.
23. Air cooling window
Make sure these inlet remains clear to allow unrestricted air flow.