DAPAudio IMIX-7.2 USB, Руководство пользователя

Страница: 10 / 16

9
IMIX 7.2 USB
Ordercode: D2352
18. Output signal VU-meter (master A/B)
This meter is a multi-step LED. The accurate level indication allows you
to monitor the output signal level at anytime, and match with other
devices.
19. Balance control
By using the bal(ance) control you can adjust the balance between
the left and the right channel. If you use a mono source (input left
mono) the control works as a pan(orama) control and lets you
change the input signal’s position within the stereo image.
20. Master control (master A/B)
Allows you to adjust the output signal to the master A/B (33,44,45)
outputs.
21. Power on/off switch
Do not supply power before the whole system is set up and
connected properly.
22. Monitor volume control
Allows you to adjust the output signal to the monitor (34) output.
23. Mic 1 input combo connector
Electronically balanced combo-type input for connecting low
impedance microphones. The input has extremely low noise and low
hum. When connecting a microphone make sure that the pin
assignment is correct. Always make sure to read the manual of the
microphone you want to connect. The combo- input is not suitable for
connecting an additional mixing console, FX- unit, etc. You have to
use the line
(26,28,36-40) inputs, when connecting this kind of
equipment.
Note: When connecting signal sources, please make sure the corresponding channel faders and the
master faders are at their minimum settings. Otherwise unpleasant plug-in noise can occur.
24. Channel select switch
Allows you to assign a source to your headphone section. You are able to select: mic 1, mic 2, channel 1,
channel 2, channel 3, channel 4, channel 5, master A or master B.
25. Headphones level control
This control allows you to adjust the headphones’ volume.
26. Aux mini jack in connector
Unbalanced stereo mini jack aux input for connecting a line/phones level device. Use the Phone/Line ()
switch to set up this input for connecting either headphone or line level output devices.
27. Headphone out connector
You can connect a pair of headphones with an impedance of 32 - 600 Ohm to the headphones
connector. It is a 6,3mm/
1 /4” TRS socket, wired as Tip=left, Ring=right and sleeve = ground.
Caution: Depending on the type of headphones connected to the Headphones jack, the IMIX-7.2 is
capable of producing high output levels via the phones output. Therefore, make sure to turn the
control all the way to the left (minimum setting) before connecting the headphones. Be aware of the
fact that listening to loud sound pressure levels over a longer period of time leads to hearing damage!
28. Aux RCA in connectors
Unbalanced stereo RCA aux input for connecting a line/phones level device. Use the phone/line (29)
button to set up this input for connecting either headphone or line level output devices.