DAPAudio GIG-1000CFX, Руководство пользователя

Страница: 19 / 28

Ordercode: D2286
GIG-1000CFX
Installation and connection
At this point you are in a position to successfully operate your GIG-1000CFX Mixing Console. However, we
advise you to carefully read the following section to be a real master of your own mixer. Not paying
enough attention to the input signal level, to the routing of the signal and the assignment of the signal will
result in unwanted distortion, a corrupted signal or no sound at all. So you should follow these procedures
for every single channel:
• Before connecting mics or instruments, make sure that the power on all your system components,
including the mixer, is turned off. Also, make sure that all the input and output controls are turned
down. This will avoid damage to your speakers and avoid excessive noise.
• Properly connect all external devices such as mics, power amplifiers, speakers, effect processor, etc.
•
Now, turn on the power of any peripheral devices, then power up the mixer.
• Set the output level of your mixer or the connected power amplifier at no more than 75%.
•
Set the CONTROL ROOM/PHONE level at no more than 50%.
•
Position HI, MID and LOW EQ controls on middle position.
• Position panoramic (PAN/BAL) control on center position.
•
While speaking into the mic (or playing the instrument), adjust the channel Level control so that the
PEAK LED will occasionally blink, in this way you will maintain good headroom and dynamic range.
•
You can shape the tone of each channel by adjusting the equalizer controls as desired.
•
Now repeat the same sequence for all the input channels. The main LEDs can move up into the red
section, in this case you can adjust the overall output level through the MAIN MIX control.
18