9
Order code: D3688
EVO 5A
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
If the speakers do not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the speakers, the fuse.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02)
The speakers. Return the EVO 5A to your DAP Audio dealer.
03)
The fuse. Replace the fuse. See page 8 for replacing the fuse.
04)
If all appears to be O.K., plug the unit in again.
05)
If you are unable to determine the cause of the problem, do not open the EVO 5A, as this may
damage the unit and the warranty will become void.
06)
Return the device to your DAP Audio dealer.
Sound Warping
If the sound coming out of your speaker is loud enough, but seems to be warped or distorted, your treble
or bass levels may need to be adjusted.
If there are not many pieces of furniture in the room and the floor has no carpet or rug, then you will most
likely have to turn your treble down. With very little in the room to absorb the sound, too much treble can
make the sound bounce off fixtures in the room, making it sound tinny.
With the bass, if the speaker is too close to a wall and is not aimed properly, then you will need to turn the
bass down, to stop the low tones from bouncing off the walls or large pieces of furniture.
Product Specifications
Input voltage:
240 V AC, 50 Hz
Power consumption:
2 x 25 W
Speaker system:
Active 2-way full range
Sensitivity W/m:
89 dB
LF driver:
5,25” Woofer
HF Driver:
1” Mylar Dome Tweeter
Dispersion:
110° x 90° HxV
Frequency response:
80 Hz – 20000 Hz (+/-3 dB)
Connection:
RCA line connector unbalanced IN, line connector balanced IN,
C8 power IN, speaker connector OUT
Mounting:
60° multi-angled bracket
Housing:
ABS
Grill material:
Steel
IP rating:
IP20
Fuse:
T1L/250V
Dimensions:
202 x 160 x 255 mm (LxWxH)
Weight:
3,04 kg (active speaker); 1,94 kg (passive speaker)
Design and product specifications are subject to change without prior notice.
Содержание EVO 5A
Страница 11: ...10 Order code D3688 EVO 5A Dimensions...
Страница 12: ...2019 DAP Audio...
