6
Installation
Remove all packing materials from the DSP-2448 MKII. Check that all foam and plastic padding is removed.
Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Install this device on a flat surface, not bending or curved.
Do not supply power before
all components of the system are
set up and connected properly.
Menu Functions
Press the PROG-Button (
3
) to select a program and the LCD screen will display the program effect.
In the display the “
:
” symbol is blinking, to indicate you can change the program from P1-P48.
Press the PROG-Button (
3
) again to select USER PROGRAM EFFECT.
You can now select any program memory from U1-U48 by turning the jog-wheel.
Parameters
Press the PARAM-Button (
6
) to edit the present parameter shown in the display. If the “
:
” symbol is blinking,
you can adjust a parameter by using the jog-wheel (
2
). When you keep pressing this button, you are able to
select different parameters. SV keeps blinking in the top right corner of the display, meaning the parameter
has been edited and reminding the user to save his changes or not. Press the STORE-Button (
8
) to save
the edited value.
Example: If you want to edit all the P02 parameter values.
Press the PARAM-Button (
6
) and the display shows REV MIX: 50%. In the display the “
:
” symbol
is blinking, to indicate you can use the jog-wheel to increase REV MIX: 50% to REV MIX: 70%.
Press the PARAM-Button (
6
) again, the display will show REV TIME: 7.0s. In the display the “
:
”
symbol is blinking, to indicate you can use the jog-wheel to decrease the value from 7.0s to 6.8s.
Press the PARAM-Button (
6
) again, the display will show REV H FREQ. In the display the “
:
”
symbol is blinking, to indicate you can use the jog-wheel to increase/decrease the parameter
values.
Press the PARAM-Button (
6
) again, the display will show REV L FREQ. In the display the “
:
”
symbol is blinking, to indicate you can use the jog-wheel to increase/decrease the parameter
values.
Press the PARAM-Button (
6
) again, the display will show REV DENS. In the display the “
:
”
symbol is blinking, to indicate you can use the jog-wheel to increase/decrease the parameter
values.
Press the PARAM-Button (
6
) again, the display will show RV LPF. In the display the “
:
”
symbol is blinking, to indicate you can use the jog-wheel to increase/decrease the parameter
values.
Содержание DSP-2448 MKII
Страница 1: ...DSP 2448 MKII ORDERCODE D2031 ...
Страница 21: ...2006 DapAudio ...