DAPAudio CS-620, Руководство пользователя

Страница: 6 / 8

Ordercode: D6583
CS-620
Installation
01) Drill a hole in the ceiling, using the template from the box (ø 225 mm).
Fig. 01
02) Connect the power supply to the speaker. Connect the common cable to the COM connector.
Connect the main feed cable to one of the following 3 connectors: 5/10/20W.
03) Extend the clamps and fit the speaker into the hole on the ceiling. Pull the clamps down to secure
the speaker.
Fig. 02
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speakers.
Low and Poor Sound
If your ceiling speakers are working but the sound volume coming from them is low, check the speakers
to see if they are well insulated. If the speakers were installed and there was no insulation around or
behind them, you are going to want to add some. Adding insulation will help to buffer the sound and
stop it from going up into your attic. It will also make sure that the speakers are secure in the holes, and
won’t vibrate.
Uneven Sound
If you put the insulation in unevenly, then this could result in uneven sound. Make sure to put in the same
amount of insulation around each speaker. If some speakers are packed tightly, while others just have
the insulation loosely around them, then you will end up with different levels of sound absorption.
5