DAPAudio Compact Array D3710, Руководство по установке

Страница: 5 / 13

3
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged. Check the system and the power-
cord from time to time.
The cable insert or the female part in the device must never be strained. There must always be
sufficient cable to the device. Otherwise, the cable may be damaged which may lead to deadly
electrical shocks
Always operate the unit with the AC ground wire connected to the electrical system ground.
Do not drive the inputs with a signal level bigger, than required to drive the equipment to full
output.
Please turn off the power switch, when changing the power cord or signal cable, or select the
input mode switch.
In typical use, Please set the volume to 0dB position.
Prevent distortion! Make sure that all components connected to the Sound mate have sufficient
power ratings. Otherwise distortion will be generated because the components are operated at
their limits.
Avoid ground loops! Always be sure to connect the power amps and the mixing console to the
same electrical circuit to ensure the same phase!
If system is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
If the system has been exposed to drastic temperature fluctuation (e.g. after transportation), do
not switch it on immediately. The arising condensation water might damage your system. Leave
the system switched off until it has reached room temperature.
If your DAP Audio device fails to work properly, discontinue use immediately. Pack the unit
securely (preferably in the original packing material), and return it to your DAP Audio dealer for
service.
For replacement use fuses of same type and rating only.
The user is responsible for correct positioning and operating of the Concert Series. The
manufacturer will not accept liability for damages caused by the misuse or incorrect installation
of this device.
This device falls under protection class I. Therefore it is essential to connect the yellow/green
conductor to earth.
Repairs, servicing and electric connection must be carried out by a qualified technician.
SAVE YOUR INVOICE. It will be required for warranty service if needed in future.
WARRANTY: Till one year after date of purchase.
OPERATING DETERMINATIONS
If this system is operated in any other way, than the one described in this manual, the product may suffer
damages and the
warranty becomes void.
Any other operation may lead to dangers like short-circuit, burns, electric shock, etc.
You endanger your own safety and the safety of others!
Improper installation can cause serious damage to people and property!
Rigging
Please follow the European and national guidelines concerning rigging, trussing and all other safety
issues.
Do not attempt the installation yourself!
Always let the installation be carried out by an authorized dealer!
Procedure:
If the projector is lowered from the ceiling or high joists, professional trussing systems have to be
used.
Use the DAP mounting frame (D3715) in combination with approved Safety slings to suspend the
Compact array from the trussing system.