DAONE Food Cofman DW-101 AG, Руководство пользователя, Страница: 4 / 17

Successful Installation
If not installed correctly by qualified personnel, the coffee maker may operate properly any
damage may result. Damages resulting from improper installation are not covered by the warranty.
Here are the key points to consider before installation.
Electrical Connection
1. Verify that the actual voltage at the electrical service connection is compatible with the
specifications on the coffee maker's label.
2. All Cofman coffee makers require NEUTRAL. Ground is not an acceptable substitute.
Installation without neutral may cause the electronic components to damage.
3. Power cords and plugs are shipped your national electrical configurations.
Coffee Maker (DW101 AG) Setup
1. Turn on the incoming water supply line and inspect both inside and
outside of the coffee maker for leaks in all fittings and tubes.
2. Turn off the Security Thermostat (EGO).
3. Turn on the coffee maker 's main power switch.
4. As SOLENOID VALVE opens, water is filled to water tank. The heaters
will be disabled by the Security Thermostat (EGO) until the tank is full.
5. As shown in the figure, please dial according to the specified location.
[CAUTION] If the thermostat is set higher temperature than standard, it can cause boiling
and mechanical problems.
Water connection
1. The coffee maker can be connected to a cold water line, and
that the water pressure is between 1~5 bar.
Flush the water supply line and filter before connection it to the
coffee maker .
2. Must be used the water filter, it should be installed after the off
valve and in a position to facilitate filter replacement.
DW 101 AG - Installation
I n s t a l l a t i o n
DW 101 AG
01 . 60