DanVex DEH-900i, Руководство по эксплуатации

Страница: 16 / 20

R
www.danvex.fi
1
5
Operation Notices
1. When moving the machine, do not incline the machine for over 45°to avoid
damaging the compressor.
2. Temperature for operation of this machine is 5-35
℃
.
3. When it is operating
，
the compressor gives off heat when it works
，
and
ambient temperature may rise by 1-3
℃
.Such phenomenon is normal and is safe to use.
4. When ambient temperature is below 10
℃
and absolute humidity is relatively
low
，
there is no need to use dehumidifier.
5. The air inlet and outlet must be away from the wall for at least 10cm in order
not to impair the dehumidification effect.
6. Working environment shall be as airproof as possible to maximize
dehumidification on effect.
7. Dust on the air purification filter mesh may impair its effect or even cause
failure. Please clear regularly for at least once a month. If there is much dust in the
environment
，
it must be cleared once a week or once a day. Pull down the front
panel
，
clear the filter mesh. Tap the filter mesh slightly or eliminate the dust by vacuum
cleaner or place the mesh in warm water （ ≤40℃ and add appropriate neutral
scour ） and brush and then wash with clear water and dry it. Direct sunlight or baking
shall be avoided to prevent deformation.
Failure Cause analysis Method
Dehumidifier
cannot work
1.Power cut
2.Power switch is not
energized
3.Power cord is not
connected
4.Fuse is melted
1.Recover the power
2.Energize the power
3.Connect the power cord
4.Replace the fuse
Dehumidification is
not ideal
1.Dust accumulated in air
purification filter mesh
2.Object blocking air inlet
and outlet
3.The door or window is
open
4.Refrigerant is leaking
1.Clear the filter mesh
2.Remove the blocking
object
3.Close the door and
window
4.Contact with distributor or
manufacturer for repair
Water leak 1.The machine is inclined
2.Water pipe is blocked
1.Level the machine
2.Remove the blocking
object
Abnormal noise 1.The machine is not
placed solidly
2.The filter mesh is
blocked
1. Place the machine firmly.
2. Clear the filter mesh.
Common Troubleshooting