R
www.danvex.fi
12
Operation Guide
Proper settings of Heating, Dehumidifying and Fan modes
Mode Selection ( 1 )
Press "Mode" button to select the required working mode,
Which is changed in the following sequence when press once:
Automatic Dehumidifying Fan Heating
NOTE:
Automatic operation will be explained in detail on next page.
Air Flow Selection ( 2 )
Press "FAN" button to select the required fan speed, Which
is changed in the following sequence when press once:
Automatic Low Mid High
NOTE:
When automatic FAN is selected, the dehumidifier will
automatically select the suitable amount of air flow according to
room temperature.
When dehumidifying is selected, the amount of air flow is set
by the machine and fan setting is not functional.
Temperature Setting Selection ( 3 )
Press "Temperature Adjustment Button " to set temperature 1 degree higher.
Press "Temperature Adjustment Button " to set temperature 1 degree lower.
Hold down the Button to increase of decrease the temperature settings progressively.
NOTE:
Range of adjustable temperature settings : 18 C ~ 31
℃
.
Starting Operation ( 4 )
Press "On/Off" button, and when the unit receives the signal, it gives out two "beep" tones,
the operation light is on and the dehumidifier starts operation.
NOTE:
If it is desired to run the machine at the same settings for mode, air flow and temperature as the last operation
skip Steps 1~3 and start the machine directly. If the interval is shorter than 3 minutes from last shut down to
the present switch-on, the compressor only re-starts after 3 minutes to protect the system. After switching on
and if the mode is changed, the system may delay for 3 minutes before starting operation.
When heating mode is selected, the internal fan will delay operation for a while when the machine is switched
on to prevent cool air circulation at the beginning. After switching on, air flow amount and temperature may be
separately adjusted as desired.
