Dantherm calorex WA 634ACL, Инструкция для владельца и по установке

Страница: 48 / 52

WARRANTY CONDITIONS.
for Pool water applications
pH 7.2 - 7.8
Total Alkalinity 80 - 120 ppm as CaCO
3
Total Hardness 150 - 250 ppm as CaCO
3
Total dissolved solids 1000 ppm
Saline Water 8000 ppm
Chlorine - free Cl Range 1.0 - 2.0 ppm Domestic
Chlorine - free Cl Range 3.0 - 6.0 ppm Commercial
Ozone 0.9 Max ppm
Bromine 2 - 5 ppm
Baquacil 25 - 50 ppm
Aquamatic Ionic Purifier Max 2 ppm Copper
for Potable water applications
TEST RECOMMENDED LEVELS
Appearance Clear to slight haze, no debris
pH 6.6-8.5
Conductivity μS/cm More than supply mains water
Chloride ppm Less than 125
Excess Chloride ppm Less than 50
Total hardness as CaCO
3
ppm 50 to 200
Hardness deposition % Less than 30
M alkalinity as CaCO
3
ppm 300 more than supply mains
Sodium ppm 50 less than supply mains water
Potassium ppm Less than 60
Aluminium ppm Less than 3
Iron ppm Less than 50
Copper ppm Less than 3
Phosphorus ppm Less than 80
Boron ppm More than 150
Molybdenum ppm More than 20
The following exclusions apply to the Warranty given by Dantherm Ltd. No
claims will be accepted if :
1. The heat pump is incorrectly sized for the application.
2. The heat pump is installed in any way that is not in accordance with the
current procedures as defined by Dantherm Ltd.
3. The heat pump has been worked upon or is adjusted by anyone other
than a person authorised to do so by Dantherm Ltd.
4. The air flow to and from the machine is outside the specified limits.
5. The water flow through the machine is outside the specified limits.
6. The water pH level and/or chemical balance is outside the following limits:
7. The heat pump has suffered frost damage.
8. The electrical supply is insufficient or in any way incorrect.
9. The fan amps and duct pressure are outside the specified limits.
10. The heat pump has not been maintained in accordance with service
requirements in section 4.1.
If in doubt or if advice is required please contact the Dantherm Group
UK Service Department by calling 01621 856 611 (option 4) or
emailing service.department@dantherm.com
Note: The Reply Paid Warranty Registration Card must be returned, to ensure
that the correct warranty is given. If you do not find a Registration Card with
your heat pump please contact the Dantherm Service Department giving your
name, address and serial number of your heat pump. A card will be sent to you
for completion.
Please give MODEL NUMBER and SERIAL NUMBER of your heat pump when
making technical or service enquiries. This will assist in correct diagnosis and
ensure service can be provided with the minimum delay.
48 SD331852 ISSUE 7
OWNER INSTALLATION MANUAL 634ACH/ACL/AHC /1222AC/1234BC/BHC /1834BHC /PP22BC